![]() There's also a more advanced PrusaSlicer some of the Voron people are using and they seem to prefer it. I'll be doing more tuning with PrusaSlicer in the future. However, the part that was printed was looking really clean before the print failed. Only problem I had was a layer shift, because I was printing at higher acceleration/jerk values than before trying to tune my corner quality. WOW, I didn't do much tuning at all, I basically just copied some settings from Cura to PrusaSlicer and right out the gate my print quality was much better. I was about fed up with Cura and decided to just try PrusaSlicer. Keep in mind I printed with a Micro Swiss clone (Gulfcoast Robotics) hot end and 0.6mm nozzle before using the same Cura settings and got much better quality prints. Academy Blog Company PrusaSlicer 2.5.2 released An open-source, feature-rich, frequently updated tool that contains everything you need to export the perfect print files for your 3D printer. I printed some components for the bullet trays I sell and honestly the quality was not to my usual standards. I didn't see any need to switch since all my previous prints turned out great. I pretty much consider myself a Cura expert by now and that's one reason I didn't try PrusaSlicer earlier. Why Uniform Flowrate Is Important PRUSA SLICER How To Check and Adjust Your Flow RateHelp Reaching 10 000 Subs. It helped the other corners, but really did nothing to the corner where the z seam was. Max volumetric speed Max volumetric speed Relevant for: Plus 1.75 mm MK2.5 MK2. Describe the solution youd like I would like a new parameter added into print settings -> Advanced -> Flow called 'Inital Flow Ratio' Describe how it would work Upon entering an initial flow rate it will embed M221 S into the gcode for layer 0. Nothing I did in Cura resolved the issue and I even tuned my linear advance. However, within prusaslicer, there is no Inital Layer Flow Rate. With the 0.4mm nozzle I was getting great prints, then I switched over to the 0.6mm nozzle and I noticed very large rounded corners at the z seams of the calibration cubes I was printing. A couple of weeks ago I installed the Triangle Labs version of the Phaetus Dragon hot end on my Ender 5.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |